For Concrete Ceiling
For the most common ceiling-mounted installation, you can directly embed the chandelier lift within the suspended ceiling, ensuring the lift remains invisible from the outside and eliminating the need for an additional decorative cover, as illustrated in Figure 1-1.
If the installation site features an exposed ceiling, simply use expansion bolts for installation. We recommend purchasing a decorative cover in white or gold for a neat appearance, as shown in Figure 1-2.
For Wooden Ceiling with Joists(16'')
Concealed mounting: requires installing two steel bars across the joists and securing the lift through pre-drilled holes. This method keeps the lift hidden and eliminates the need for a decorative cover, but drywall repair will be required. You can contact a contractor to plan this project.
Figure-1-3
Surface mounting: Requires removing a section of drywall based on the joist layout. Install the two steel bars horizontally across the joists, then mount the lift on the steel bars. A decorative cover is then installed underneath. In most cases, drywall repair is unnecessary, as the decorative lift cover effectively conceals the backer board.
Figure-1-4
Note: If there is a significant gap between your lift and the ceiling (drywall) below, preventing the chandelier from reaching the ceiling, you can use a steel chain to connect to the gear underneath the lift. The length of the chain should be adjusted based on the actual situation, as shown in the picture(Figure-1-5).
Figure1-5
For Ceiling Joist Spacing Over 16''
If your ceiling joists are spaced wider than 16’’ (e.g., 24’’), you can:
- Order custom steel bars/ Steel channels with longer lengths and drill 0.8cm (5/16’’) holes to match the lift’s mounting points.
- Use a mounting base made of ½-inch plywood or ¼-inch steel plate.
If you have any questions, feel free to contact us via email or WhatsApp, and we’ll reply within 8 hours.
Email: huiyelift@gmail.com
WhatsApp: +86 13808557280 (Name: Wu Zixin)
Now, let's delve into the installation methods for some special types of ceilings:
If your ceiling is sloped or if the installation area is smaller than the back of the lifting mechanism, you will also need to embed full-threaded long screws into the ceiling and proceed with the installation by threading the lift through these screws. As same as figure 1-6 or 1-7
Note: Before purchasing and installing, please carefully assess whether the installation area can support the weight of the lift. If the installation area consists of thin wooden boards, extra caution is advised. We are not liable for any structural collapse due to the ceiling's inability to bear the weight of the lift.